ACS715 Current Sensor BreakoutProduct Code: 474
£6.50 ex VAT
RETIRED PRODUCT - This product has been retired by the manufacturer and is no longer for sale. This page remains available for it's resources and as a source of potential interest.
This 0-30A current sensor is a carrier board or breakout board for Allegro's ACS715LLCTR-30A-T Hall effect-based linear current sensor; we, therefore, recommend careful reading of the ACS715 datasheet before using this product. The sensor operates at 5 V and has an output sensitivity of 133 mV/A.Dimensions
- Size:0.7" x 0.8"
- Weight:0.04 oz
- Current sense:0.133 V/A
- Minimum logic voltage:4.5 V
- Maximum logic voltage:5.5 V
- Supply current:13 mA
- Designed for unidirectional input current from 0 to 30 A, but the sensor will provide meaningful feedback for currents as low as -1.5 A, and the robust IC can survive up to five times the overcurrent condition.
- Conductive path internal resistance is typically 1.2 mΩ, and the PCB is made with 2-oz copper, so very little power is lost in the board.
- Use of a Hall effect sensor means the IC is able to electrically isolate the current path from the sensor's electronics (up to 2.1 kV RMS), which allows the sensor to be inserted anywhere along the current path and to be used in applications that require electrical isolation. 80 kHz bandwidth that can optionally be decreased by adding a capacitor across the board pins marked filter.
- High accuracy and reliability: typical total output error of 1.5% at room temperature with factory calibration, an extremely stable output offset voltage, and almost zero magnetic hystereses.
- Automotive grade operating temperature range of -40°C - 150°C.
- The pads are labelled on the bottom silkscreen, as shown in the picture to the right. The silkscreen also shows the direction that is interpreted as a positive current flow via the arrow.
The sensor requires a supply voltage of 4.5 - 5.5 V to be connected across the Vcc and GND pads, which are labelled on the bottom silkscreen. The sensor outputs an analogue voltage that is linearly proportional to the input current. This output voltage is offset by 500 mV and increases by 133 mV per amp of the input current. The output voltage decreases linearly below 500 mV for currents as low as -1.5 A.
The input current can be connected to the board in a variety of ways. For low-current applications, you can solder 0.1" male header pins to the board via the small through-holes on the input-current side of the board. For higher-current applications, you can solder wires directly to the through-holes whose sizes best match your wires, or you can use solderless ring terminal connectors. The large through-holes are big enough for #6 screws.Mounting information
The board has two mounting holes on the logic side of the board. These mounting holes are 0.5" apart and are designed for #2 screws.Filtering the output
The IC has an internal filter resistance of 1.7 kΩ, and the carrier board includes a 1 nF filter capacitor, which produces a low-pass RC filter with a 90 kHz cutoff. You can improve sensing system accuracy for low-frequency sensing applications by adding a capacitor in parallel with the integrated 1 nF capacitor across the pads marked filter on the bottom silkscreen (this capacitor is labelled C2b in the schematic below). The frequency F that the filter will attenuate to half its original power is given by:
F = 1 / (2πRC) = 1 / (11kΩ * (1 nF + Cf))
where Cf is the value of the capacitor added to the filter pads.