Prototyping

DESCRIPTIONSo you've got a load of jumper wires running from one breadboard to the next, criss crossing over each other and the longer you stare at...

DESCRIPTIONStandard 22 AWG solid core black wire.Use this with your bread board or any project in which you need sturdy wire. Comes in small spools...

DESCRIPTIONThis is a variety pack of 75 male to male 0.1" jumpers of different colours and lengths, from 8-23cm. Unlike our other jumper wires t...

DESCRIPTION So you've got a load of jumper wires running from one breadboard to the next, criss crossing over each other and the longer you stare a...

DESCRIPTIONSo you've got a load of jumper wires running from one breadboard to the next, criss crossing over each other and the longer you stare at...

DESCRIPTIONStandard 22 AWG solid Red hook up wire. Use this with your bread board or any project in which you need sturdy wire. Comes in small spoo...

DESCRIPTION These 10-pin IDC cables are handy when programming or debugging a tiny board that uses 10-pin 1.27mm (0.05") pitch SWD programming conn...

DESCRIPTIONStandard 22 AWG solid Yellow hook up wire. Use this with your bread board or any project in which you need sturdy wire. Comes in small s...

DESCRIPTIONThis cable turns the 4 pin JST connectors of the atmospheric sensors into 4 male jumper pins that you can connect to any microcontroller...

DESCRIPTION This is a jumper adapter cable that comes pre-terminated with a female Qwiic JST connector on one end and a breadboard hookup pigtail o...

DESCRIPTIONThis adapter allows you to connect a barrel jack connector to bare wires. One end has screw terminals and the other has a 5.5x2.1mm, cen...

DESCRIPTION This is a 50mm long 4-conductor cable with 1mm JST termination. It’s designed to connect Qwiic enabled components together but ca...

DESCRIPTION This adapter consists of a 9V battery clip and a standard 5.5*2.1mm centre positive barrel jack, it supplies to power any device needin...

DESCRIPTION This is a 100mm long 4-conductor cable with 1mm JST termination. It’s designed to connect Qwiic enabled components together but c...

DESCRIPTIONStandard 22 AWG solid Brown hook up wire. Use this with your bread board or any project in which you need sturdy wire. Comes in small sp...

DESCRIPTION This is a 200mm long 4-conductor cable with 1mm JST termination. It's designed to connect Qwiic enabled components together but can be ...

DESCRIPTIONThis connector cable interfaces UFL RF connectors to RP-SMA antennas. Use it to attach any standard RP-SMA 2.4GHz antenna to the DPAC 80...

DESCRIPTION This cable is a USB to Serial (TTL level) converter cable. It's identical functionally to the FTDI Cable. It's one of the easiest ways ...

DESCRIPTION This is a 500mm long 4-conductor cable with 1mm JST termination. It's designed to connect Qwiic enabled components together but can be ...

DESCRIPTIONThis multifunction power supply test line is super useful. Whether you are checking current draw on your new board or trying out some LE...

DESCRIPTION Here is a very simple breadboard power supply kit that takes power from a DC wall wart and outputs a selectable 5V or 3.3V regulated vo...

DESCRIPTIONThis adapter allows you to connect a barrel jack connector to bare wires. One end has screw terminals and the other has a 5.5x2.1mm, cen...