PAA5100JE Near Optical Flow SPI Breakout

Pimoroni  |  SKU: 4064
£18.89
Tax included, shipping and discounts calculated at checkout.


DESCRIPTION

Detect motion of close-up surfaces with this optical navigation breakout - great for floor tracking for ground dwelling robots!

The PAA5100JE sensor is used in robot vacuum cleaners and uses a low-resolution camera and some clever algorithms to detect motion of surfaces. This sensor has a super close range of 15-35mm so it's suitable for use with a variety of different surfaces.

FEATURES
  • PAA5100JE-Q optical tracking sensor
  • Two white LEDs on-board for illumination
  • Frame rate: 242 FPS (frames per second)
  • Range: 15-35mm
  • Field of view: 42°
  • Maximum speed: 1.14 metres per second (with sensor 25mm away from the surface)
  • 6mA typical current draw
  • SPI interface
  • 3.3V or 5V compatible
  • Reverse polarity protection
  • Compatible with Raspberry Pi and Arduino
  • Measurements: approx 24mm x 24.5mm x 5mm (L x W x H, including components)
RESOURCES

If you're not using a Breakout Garden, this is how to connect your Near Optical Flow Sensor Breakout up to your Raspberry Pi.

  • 3-5V to any 5V or 3V pin
  • CS to BCM 7
  • SCK to BCM 11
  • MOSI to BCM 10
  • MISO to BCM 9
  • INT to BCM 19
  • GND to any ground pin
PAA5100JE Near Optical Flow SPI Breakout - Raspberry Pi
Pimoroni

PAA5100JE Near Optical Flow SPI Breakout

£18.89
DESCRIPTION

Detect motion of close-up surfaces with this optical navigation breakout - great for floor tracking for ground dwelling robots!

The PAA5100JE sensor is used in robot vacuum cleaners and uses a low-resolution camera and some clever algorithms to detect motion of surfaces. This sensor has a super close range of 15-35mm so it's suitable for use with a variety of different surfaces.

FEATURES
RESOURCES

If you're not using a Breakout Garden, this is how to connect your Near Optical Flow Sensor Breakout up to your Raspberry Pi.

View product