New Products

DESCRIPTION The beginner parts kit is a small container of parts frequently used by beginning (or even experienced) hobbyists that gives you all of...

DESCRIPTION The shield header kit provides you with the correct sized stackable female headers to fit with most Arduino shield projects. The header...

DESCRIPTION This is a connector that fits directly to the edge contacts of a BBC Micro-Bit. The connector has 80 pins, but because of the differen...

DESCRIPTION This is the Grove base shield as seen in the Grove starter kits for Arduino. It lets you connect Grove components easily to your Arduin...

DESCRIPTION The Grove - Speaker is a module consisting of power amplification and voice outputs. The loudness can be adjusted by the onboard potent...

DESCRIPTION This white solderless breadboard is a high-quality prototyping breadboard. Each row/column has a letter or a number, and there are two ...

DESCRIPTION This is a 4-pin JST SM Male housings. They're type SM and do require additional parts to turn them into a complete plug/connector. Ple...

DESCRIPTION This massive kit has 280 parts! The electronic parts kit is a comprehensive selection of components for making a wide variety of elect...

DESCRIPTION This 3.3V Buck Converter Breakout board is great for supplying power to low voltage circuits from a single Li-Ion cell battery or USB ...

DESCRIPTION The SX1509 Breakout is a 16-channel GPIO expander with an I2C interface that means with just two wires, your microcontroller can inter...

DESCRIPTION The 8-Pin SOIC to DIP Adapter is a small PCB that lets you adapt SOIC packages into a DIP footprint. These tiny boards are useful for ...

DESCRIPTION This adapter consists of a 9V battery clip and a standard 5.5*2.1mm centre positive barrel jack, it supplies to power any device needin...

DESCRIPTION The Grove relay is capable of switching much higher voltages and currents than your normal Arduino boards. When set to HIGH, the LED wi...

DESCRIPTION This is a 16GB class 10 microSD card that comes with a pre-installed with NOOBS operating system and an adapter for an SD card slot. Th...

DESCRIPTION The Si5351A clock generator breakout from Adafruit allows you to generate any clock frequency from 8Khz up to 160MHz. The clock generat...

DESCRIPTION This 2x20 shrouded header has the same number and spacing of pins as the Raspberry Pi 3 so you can easily connect via ribbon cable to ...

DESCRIPTION Connect to nearly any kind of FPC/flex cable with the 40-pin FPC to breadboard adapter plate. You get 40 pads of 0.5mm, 0.6mm, 0.7mm, 0...

DESCRIPTION This adapter allows you to connect a barrel jack connector to bare wires. One end has screw terminals and the other has a 5.5x2.1mm, ce...