Newest Products

DESCRIPTION The SparkFun Qwiic LED Stick features ten addressable APA102 LEDs, making it easy to add full colour LED control using I2C. Write to in...

DESCRIPTION A U.FL to SMA (jack) bulkhead straight connector with a 1.32 mm diameter cable. Less than -2 dB cable insertion loss up to 6 GHz. Both...

DESCRIPTION The SparkFun SGP40 Air Quality Sensor provides a measurement of the quality of the air in your room or house. The SGP40 is based on Se...

DESCRIPTION The DHT20 is a low-cost humidity and temperature sensor with an I2C digital output protocol. It can be applied to HVAC, dehumidifier, ...

DESCRIPTION If you love the Maker UNO but find that it's too big to fit into your project? Worry not! Introducing Maker Nano, an Arduino board spec...

DESCRIPTION The Maker Pi Pico is a great all-in-one board for beginners and experienced makers alike, it comes with a Raspberry Pi Pico pre-soldere...

DESCRIPTION These MakerDisk microSD cards have been tested and approved by the Raspberry Pi Foundation for use with Raspberry Pi Products. It come...

DESCRIPTION If you want to store calibration values, MAC addresses, non-secure access tokens, or other unique identifiers, EEPROM storage is a grea...

DESCRIPTION The SHT30-D sensor has an excellent ±2% relative humidity and ±0.5°C accuracy for most uses. Unlike earlier SHT sensors, this sensor ha...

DESCRIPTION A minimal RP2040 breakout board wrangled into a Pin Grid Array, with 8MB flash and a maximal dash of retraux style. PGA2040 is a compac...

DESCRIPTION The MonkMakes Air Quality Kit for Raspberry Pi is based around the MonkMakes Air Quality Sensor board. This add-on for the Raspberry Pi...

DESCRIPTION The MonkMakes Solar Experimenters Kit for micro:bit is a project kit that allows you to experiment with harvesting energy from the sun...

DESCRIPTION This one's going out to all the makers and designers who love using terminal blocks for wiring up their projects. This adapter plate is...

DESCRIPTION This sensor is essentially a reed switch, encased in an ABS plastic shell. Normally the reed is 'open' (no connection between the two w...

DESCRIPTION This plug-and-play PCB is designed to slip into any USB A port on a computer or laptop. There's an RP2040 microcontroller on board with...

DESCRIPTION Witty Pi 3 Mini adds RTC (DS3231SN) and power management to your Raspberry Pi, and can define complex ON/OFF sequence with simple scrip...

DESCRIPTION This module is the best way to add a GPS to your wearable project. It's part of the Adafruit Flora series of wearable electronics, desi...

DESCRIPTION Infrared (IR) break-beam sensors are a simple way to detect motion. They work by having an emitter side that sends out a beam of human...

DESCRIPTION Infrared (IR) break-beam sensors are a simple way to detect motion. They work by having an emitter side that sends out a beam of human...

DESCRIPTION This control board is designed to make using NeoPixel and DotStar LED strips and rings as easy as possible with a Teensy microcontroll...

DESCRIPTION The Pico-UPS-A is a dedicated UPS (Uninterruptible Power Supply) module designed for Raspberry Pi Pico. It incorporates a Li-ion batter...

DESCRIPTION The Pico-RTC-DS3231 is an RTC expansion module specialized for Raspberry Pi Pico. It incorporates high precision RTC chip DS3231 and u...

DESCRIPTION 1.3inch OLED Display Module For Raspberry Pi Pico, 64×128 Pixels, SPI/I2C Interface.1.3" OLED Display Module is Embedded SH1107 Driver,...

DESCRIPTION The SparkFun Qwiic micro:bit Breakout is a board that connects to the BBC micro:bit and expands the capabilities of the development pla...